Showing posts with label energy. Show all posts
Showing posts with label energy. Show all posts

Saturday, December 17, 2011

The Pros and Cons of Low Energy LED Lighting

!±8± The Pros and Cons of Low Energy LED Lighting

For most people, probably the biggest single factor against low energy LED lighting as a substitute for the soon-to-be-phased-out regular incandescent light bulb is the cost differential. There is no doubt that an LED equivalent light bulb (for example a 6w LED spotlight as a direct replacement for a 35w GU10 halogen lamp) is significantly more expensive than either the original or a CFL alternative.

There are however three important points to bear in mind about the higher price for low energy LEDs as compared to incandescent and energy saving CFL light bulbs.

First, the price difference reflects the fact that the use of LED for general purpose domestic lighting is still quite novel, though increasing manufacturing levels and consumer take-up will drive the price down dramatically once both come fully on stream over the coming months.

Second, and partially related to the observation above, is that the cost of LEDs drops by a factor of twenty over the course of each decade. This characteristic is reliably predicted by Haitz's Law (very similar to Moore's Law for computer chips and for similar reasons, principally because LEDs are, just like computer chips, pure electronic devices). Haitz also states that LED performance (amount of light per watt of electricity) increases tenfold over the same decade.

Third and perhaps most intriguing is the fact that as far as the cost of domestic lighting is concerned, the price of light bulbs is almost entirely irrelevant. It is an extraordinary yet easily provable fact that even if regular light bulbs were totally free and LED lights cost, let's say something outrageous like each, it would still be vastly more economical to purchase LED low energy lights.

The reason for this is simple: the cost of electrical lighting is the cost of the energy i.e. electricity. It matters not one jot what the actual light bulbs cost; it's what it costs to run them that really counts. Also, since LEDs last for tens of thousands of hours (in practice, decades of use) you only need to pay the purchase price once, unlike regular bulbs which last only upto two thousand hours or just over one year.

The second biggest gripe about low energy LED lighting is light levels and quality, or in technical parlance luminosity and light color.

The concern about luminosity stems largely from historical notions of LED lighting applications such as LED Christmas lights and pocket torches which are clearly not capable of providing anything close to useable domestic lighting. However, you could right now purchase one of the latest Sharp Zenigata LED series of light bulbs which is rated at 80 lumens per watt (measure of luminosity).

To understand what this means, consider that a standard 40w incandescent bulb delivers about 360 lumens and a 60w bulb about 540 lumens, which gives a ratio of 9 lumens per watt. Anything that offers greater than 25 lumens per watt can be classed as an energy saving light bulb. Zenigata LED light bulbs consume 6.7 watts and thus produce 6.7 * 80 lumens per watt which is 536 lumens, on a par with the standard 60w incandescent light bulb.

So you could, right now, replace all your 60w light bulbs with Zenigata LED light bulbs rated at 6.7 watts and consume 1/10th (or 90% less) electricity. And remember Haitz's Law? Because of performance improvements, eighteen months from now you should be able to obtain the same 60w worth of lighting from just 3 watts.

LED light, in common with CFLs, has tended to be a somewhat cool blue colour, whereas we are more accustomed to a warmer yellow white colour. This is something that is now commonly addressed with the use of colored phosphors (these do reduce luminosity but this is in turn compensated for by the ever increasing lumens per watt yields for LEDs).

The third factor that might be considered to weigh against low energy LED lighting is that the light emitted by an LED is intrinsically directional and doesn't scatter in all directions the way that incandescent and fluorescent lights do. This is actually quite acceptable in a spotlight, flood light or bright reading lamp, but it's not especially effective for emulating general ambient lighting such as a table lamp would provide. Though again, there are LED powered general lighting light bulbs becoming more commonly available that do a reasonable job here.

Two obvious plus points for low energy LED lighting are ease of retrofit and ecological credentials (other than simply saving energy).

LED lights are widely available for all common base fittings such as mains powered GU10 and 12v MR16 spotlights and the low energy standard base GU24 as well as regular bayonet mounts and Edison screw fittings. LED lights also don't suffer from the many inherent problems associated with CFLs such as: noticeably poor start-up times; reduced lifespan caused by frequent switching on and off; and bulky unattractive bulbs.

But perhaps one of the most widely known advantages of low energy LED lighting over energy saving CFL light bulbs is that they don't contain toxic mercury vapour or other unpleasant materials, and thus do not pose a serious health risk or require tiresome and expensive disposal procedures to protect the environment.

To sum up, the main perceived disadvantages of domestic energy saving LED lighting are cost and application (luminosity and color). Yet as we have seen, the cost of a light bulb is actually a red herring - the true cost of electrical lighting is the price of electricity and on this score ultra low energy LED lighting puts everything else, including energy saving CFLs, completely in the shade (pun intended).

As regards luminosity and light quality, LED lights on balance deliver a cleaner, sharper light than CFL light bulbs and offer far more flexibility in terms of color choice and brightness.

Finally, the biggest advantage that low energy domestic LED lighting has over its rivals is that the lighting industry itself regards domestic LED lighting as the future and can barely disguise its contempt for CFLs. Lighting giants such as Philips are on record as stating that they will not invest a single dollar further into CFLs and that their entire research and development efforts are now directed at domestic LED lighting technology.

Those who follow eco-technology trends are well aware that there is a world-wide phase-out of incandescent light bulbs already well underway and scheduled to complete within the next couple of years. Given international legislation to ban incandescent lighting and lack of support for the already dated and unloved CFL, it's near certain where the future of lighting lies - with low energy LED light. And as advantages go, I'd say that one's pretty compelling.


The Pros and Cons of Low Energy LED Lighting

Lowest Price Used Polaris Atv Tri Fold Futons Immediately Makita Btd144 Buy Now

Sunday, August 28, 2011

LED lamps with energy saving lamps

!±8± LED lamps with energy saving lamps

View

Environmentally friendly options for replacing light bulbs are usually compact fluorescent lamps (CFLs) or Light Emitting Diode (LED) lamps.

Compact fluorescent lamps

Energy saving lamps are similar to conventional fluorescent lamps, which uses electricity to mercury vapor that is in the glass tube to activate. The actual impact on the atoms of mercury with ultraviolet light (UV), does not make them visible to the naked eye. The photons from ultravioletThe light hit a phosphor coating inside the lamp emitting photons of visible light, light emitted from the tube. Ultraviolet light can cause discoloration in the images or textiles. The mercury in the lamp means that the bulbs to be disposed of properly, such as compact fluorescent burst deposited in landfills, the mercury is released into the soil drainage, contamination of the food chain to the end. Some states, like California, the ban on the disposal ofmercury-containing lamps in the trash. Some state laws require the collection of fluorescent lamps as hazardous waste or recycled properly. Check with the EPA place to ensure proper disposal procedures for your condition, or you can find a recycling center in your area Earth911.

Unlike fluorescent tubes, which are not integrated circuits, compact fluorescent lamps, in general, all the circuitry required at the base of the light from the single device used in a standardBulb light socket. Compact fluorescent lamps in a variety of styles and forms, but often are seen in a tube or spiral. Larger surface area allows more light output in compact fluorescent lamps.

LED Lighting

Solid-state lighting, better known as known LED (Light Emitting Diode) lighting is an integral part of the semiconductor light source that is not a gas pipe as the CFL. Light from an LED is when the current is applied across the semiconductor doped with impuritiescreating half, the "p-side", the other half, the "n-page" forms. The charge carriers (electrons and holes) flow into the pn junction where the two halves to meet, and releases energy in the form of a photon, so light. The color of light emitted depends on the materials forming the pn junction. There is no filament to burn out, and in contrast with energy-saving lamps, LED lamps do not contain toxic mercury, no ultraviolet light.

An emission of light, many elderlyModels of LED lamps have many individual LEDs used in a home, driving many of the new LED lights feature a single high-power LEDs. These LED lamps are much smaller than their counterparts in the CFL, and are offered in the form factors to produce a directed beam of light provided by the use of a lens of glass or plastic, and enclosed behind a frosted diffuser broader lighting .

Summary of benefits

Less expensive powerBill:

Although the cost of the bulbs are more expensive initially, CFL and LED bulbs save money in the long term. Less electricity is used, and the lamps are replaced less frequently. LEDs consume about half the amount of current compact fluorescent lamps, which use the same light output.

Long term:

Execution times of the CFL bulbs typically range from 6,000 hours to 15,000 hours, while the typical lifetime of a bulb is about 1,000 hours. An LED bulb can last50000-60000 hours, which equals about 5 or 6 years (10 times longer than a CFL).

High-quality lighting performance:

Both CFL and LED lamps, now offers a range of color temperatures. Consumers are no longer limited to blue, "cool white" bulbs of the past and can now warmer colored lamps. Inferior quality CFL bulbs, which use a magnetic ballast flicker. Look for an electronic ballast when you buy a CFL. The LEDs are controlled so as not toflicker.

Versatility:

Interior, exterior, home or commercial LED and CFL bulbs can be used in many different types of applications where traditional light bulbs were once used. LED lamps and compact fluorescent lamps can be used in track lighting, table lamps, outdoor lighting, recessed lights and ceiling lights. Both types of lamps are dimmable models for use with a dimmer standards.

Duration:

Because the LED bulbs do not use a filament like incandescent lamps,They are shock resistant and can be used in high vibration.

Summary of disadvantages and limitations

Compact fluorescent lamps:

No spotlight - Because CFLs do not project a focused beam is used as an LED lamp, which are best for lighting the area.

Sensitivity to temperature - energy saving light bulbs are sensitive to heat, their lives will be diminished if the device will not heat properly discharged. CFLs are also affected by the cold. CFL takes much longer to reach full brightness in coldWeather. In extreme situations, can not heat properly.

Warm-up time - LED on immediately, while compact fluorescent lamps take a few minutes to heat and provide maximum brightness.

Hazardous waste - energy saving bulbs contain mercury and must be disposed of properly. The EPA provides the proper disposal site. LEDs contain no mercury.

Cycling often reduces the life - in high traffic areas such as bathrooms at home, where energy saving lamps and out often, theirLife is sinking fast.

CFL bulbs can emit UV light that can not be desirable for some applications - UV.

LED:

High cost - The LED lamps themselves are expensive, but the initial investment is recovered quickly in lower bills.

Heat generation - Some high-power (5 W and higher) can cause significant heat LED lamps. Heat sinks are often made in the same light bulbs and can some LED devices to ensure the necessaryadequate airflow.

LED lights are the right choice for energy efficient lighting because of their different lighting options, and the ease with which the light emission can be layered and controlled when compared to CFL bulbs.


LED lamps with energy saving lamps

Sudanese Music Order Buying Wireless Invisible Fence


Twitter Facebook Flickr RSS



Français Deutsch Italiano Português
Español 日本語 한국의 中国简体。







Sponsor Links